Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
Assembly
10.3.8 Installing lower part of back panel
If using threaded connections for finished walls, the lower part of
the back panel can also be installed after fitting the taps/valves.
To do this, carry out the following steps:
f Cut open the lower part of the back panel.
f
f Fit the lower part of the back panel by bending it out at the
f
sides and guiding it over the pipes.
f Insert the connection pieces from behind into the lower part
f
of the back panel.
f Click the lower part of the back panel into place.
f
f Secure the lower part of the back panel with a screw.
f
1
3
1 Lower part of back panel
2 Connection piece from the pack
3 Screw
10.3.9 Installation in case of appliance replacement
An existing mounting bracket can be used when replacing Stiebel
Eltron appliances (except "DHF"). For this, open a suitable knock-
out in the back panel for the stud of the existing mounting bracket.
If the appliance is being installed in place of a DHF, move the
stud on the mounting bracket as shown in the diagram "Mount-
ing bracket for DHF appliance replacement". The stud cuts its own
groove. Then turn the mounting bracket through 180° to be mount-
ed on the wall. The logo "DHF" is then turned towards the reader.
If replacing a third party appliance, suitable holes for rawl plugs
can be used.
Mounting bracket for DHF appliance replacement
12
|DHB-E electronic
2
10.3.10 Undersink installation with turned appliance cap
The appliance cap can be positioned on the back panel turned
through 180°. This is particularly advantageous for undersink in-
stallation. For this take the following steps:
f Remove the user interface from the appliance cap by undoing
f
both screws.
f Turn the appliance cap, and secure the user interface again.
f
f Plug the set value transducer cable into the "set temperature"
f
PCB; see "Commissioning".
f Hook the appliance cap back into the top and pivot it down
f
against the back panel. Push the appliance cap onto the back
panel until it audibly clicks home.
f Close the appliance with the screw in the cap.
f
Appliance cap for undersink installation
electronic
electronic
° C
electronic
electronic
electro
nic
CLICK
www.stiebel-eltron.com
Capítulos
Tabla de contenido
