Switching On And Off; Cutting; Cutting With Rip Fence; After Use - Parkside PTS 500 C3 Indicaciones De Funcionamiento Y Seguridad

Switching on and off

Q
Switching on:
1. Slide the on / off switch
switch the product on.
Switching off:
1. Release the on / off switch
product off.
Releasing the plunge lock
Q
1. Slide the plunge lock button
release the plunge lock.
NOTE
Always ensure smooth movement of the
u
product through the base plate
beginning a cut. It must not jam and the
spring assistance must be able to push back
the product through the base plate
own.

Cutting

Q
Avoid damaging the cutting edge of sensitive
o
materials, e.g. coated chip boards or doors,
by sticking masking tape along the cutting
line. Another benefit of this is that it is easier
to mark a line on the tape than on a shiny
surface. An even more effective method of
protecting the cutting edges is to clamp a
thin piece of wood along the cutting line (this
wood is also sawn).
Saw in the direction of the wood grain
o
whenever possible to avoid jamming the saw
blade and fraying edges.
Take the cutting edge into consideration when
o
cutting along marked cutting lines. Do not cut
directly on the line but next to it.
Ensure the workpiece is free of obstacles like
o
nails or screws before operation. Remove
them if required.
Ensure that there is sufficient clearance for the
o
saw blade under the workpiece.
Never hold the workpiece with your hands or
o
across your leg. Secure the workpiece with
proper clamps to a stable worktop. Support
longer workpieces to avoid tilting.
Hold the product firmly with both hands.
o
Never try to operate the product with only
one hand! Keep your hands away from under
the workpiece.
74 GB / MT
backwards to
5
to switch the
5
1 forward to
before
6
on its
6
Only apply as much pressure as necessary
o
to keep the product flat on the workpiece.
Higher pressure will not increase but lower
the performance of the product and leads to
uneven results.
1. Place the product with the base plate
the material.
2. Align it as required by the desired cut through
the viewing window for the cutting
line 13 , the projected laser line or the rip
fence (see "Cutting with rip fence").
9
3. Switch the product on (see "Switching on and
off").
4. Release the plunge lock (see "Releasing the
plunge lock").
5. Plunge the saw blade slow and steady
into the material by tilting the product with
moderate pressure forward.
NOTE
The viewing window for the cutting
u
line allows spotting a marking line on the
13
workpiece. Align the marking line with the
triangular ends of the viewing
window . Likewise the projected laser line
13
is collinear and extends past the base plate
.
6
The cutting length marking
u
beginning and end of the cut when the saw
blade is fully submerged in the workpiece at
its full diameter.

Cutting with rip fence

Q
The rip fence enables exact cuts along a
9
workpiece edge and cutting strips of the same
width.
1. Loosen the rip fence locking screw
the rip fence into the rip fence slot
9
either side of the base plate
the desired width.
2. Retighten the rip fence locking screw
3. Apply light lateral pressure to the workpiece

After use

Q
1. Switch the product off, disconnect it from the
mains and let it cool down.
2. Check, clean and store the product as
described below.
on
6
7 indicates the
, insert
10
on
8
and adjust to
6
.
10