ESAB Origo Feed 304 TRUCK Manual De Instrucciones página 26

NOTE: In order to lock or unlock just turn the red crank. It's not
needed to remove it.
6) OPERATING
1) Turn ON the power source.
2) Adjust the wire speed, the power source voltage, the welding mode, the anti-stick time, the trigger
command mode and the gas flow according to the wire diameter and thickness of the material to be welded.
3) Start the welding and re-adjust the parameters, if needed.
7) MAINTENANCE
7.1) Recommendations
In normal environment and operation conditions the wire feeders, do not require any maintenance or
special service. It is enough to clean it inside once every two month with low pressure compressed air, dry
and free from oil.
After cleaning the equipment with blow dry air, check that the electric connections and components are
properly fixed. Check for possible faults in the wire isolations or electric cables, including the welding cable
and any others and if any of them is faulty substitute it.
When working with damaged wires or cable or with worn out isolation, the non-isolated parts can become in
contact with another part of an earth connected object. The electric arc which results from this contact can
hurt the eyes if not protected and cause a fire. The body contact of a part with another conductor without
isolation can cause a violent electric hazard, burns and even death.
N.B.: Cleaning and preventive maintenance should be intensified when
operating in environment contaminated by dust, soot or any other pollutant which
can cause damage or harm to the performance.
ATTENTION:
In case of doubts about the operation or maintenance of this or any other ESAB product brand and
manufacturing, contact the department of Technical Service or an authorized ESAB Service.
26
Origo™ Feed 304 Truck