ESAB Origo Feed 304 TRUCK Manual De Instrucciones página 25

TABLE 5.4
Wire diameter (mm)
Inlet nozzle
central nozzle for Fe, Ss,C
central nozzle for aluminum
Outlet nozzle for Fe, Ss,C
Outlet nozzle for aluminum
5.4) Adjustment of the wire pressure
In order to determine the correct wire feeder pressure:
¡
Make sure that the wire moves freely through the wire guide-tube. After that, set the pressure of the
pressure roller of the wire feeder. It is important that the pressure is not too tight. To make sure that the
feeding pressure is correctly set, feed the wire out of the pistol against an isolating object, as for
example, a piece of wood.
¡
When positioning the pistol at a distance of approximately 5mm of the piece of wood (picture 1) the
feeding roller should slid.
¡
When positioning the pistol at a distance of approximately 50 mm of the piece of wood, the wire should
be fed outwards, becoming bent (picture 2).
Fig. 1
5.5) Adjustment of the brake hub
¡
Set the red crank to locked position.
¡
Inset a screwdriver in the cube springs.
¡
Turn the spring from the left to the right to decrease the locking power.
¡
Turn the spring from the right to the left to increase the locking power.
NOTE: Turn the same for the two springs.
1,60 - 2,40
0901094
0900896
0905439
0905438
0905437
Fig. 2
25
Origo™ Feed 304 Truck