Honeywell HW7000EH Manual Del Propietário página 14

Assembly
Step 2: Install Wheel Axle and Wheels
To install wheel assembly, you will need:
‰ Wheel axle (1)
‰ M8 x 16 mm long full-thread hex bolts (4)
‰ M8 serrated flange nuts (4)
*
‰ Axle bracket
(1)
‰ Wheels (2)
‰ M16 x 30 mm OD x 2.5 mm washers (2)
‰ Cotter pins (2)
‰ 12 mm open end wrench
‰ Socket wrench with 10 mm socket
‰ Needle-nose pliers
†
* Two brackets are needed to install wheel axle. One bracket
comes already attached to wheel axle; other bracket is included
in wheel kit box.
† Not included.
Install wheel axle brackets to frame using 16 mm long
1.
full-thread hex bolts and serrated flange nuts.
1A. Install pre-attached bracket to frame first.
1B. Install other bracket (included in hardware bag) to
frame.
FIGURE 7: Wheel Axle Attached to Generator
On each end of axle:
2. Slide and push wheel onto axle.
FIGURE 8: Slide Wheel onto Wheel Axle
3. Slide 9/16" washer onto axle.
8 www.honeywellgenerators.com
†
†
4. Slide cotter pin into pre-drilled hole until fully seated.
Using needle-nose pliers, bend each end of cotter pin
5.
in opposing directions to secure wheel to axle.
FIGURE 9: Cotter Pin Installation
Return generator to upright position (so that wheels
6.
and leg supports are touching the ground).
HW7000EH Portable Electrical Generator Owner's Manual