Recommended Preventive Maintenance - ProTeam GoCartVac Manual Del Usuario

Ocultar thumbs Ver también para GoCartVac:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

RECOMMENDED PREVENTIVE MAINTENANCE

WARNING
DAILY/AFTER EACH USE
Check Intercept Micro Filter. Remove and empty if full. All ProTeam vacuums must use gen-
uine Intercept Micro Filters to maintain valid vacuum warranty. Check Micro Cloth Filter. If
dirty, rinse out and air dry before replacing in vacuum. All filters must be in place to operate
vacuum. This will optimize airflow and prevent the motor from laboring.
CHARGING
See "CHARGING THE BATTERIES" section, page 8.
ELECTRICAL CORD CARE
Use only a ProTeam replacement extension cord for charging, or one that is properly sized for
your application. Extension cord jacket type should be SJT or better and rated for outdoor use.
Extension cords in poor condition or too small in wire size can pose fire and shock hazards. To
reduce the risk of these hazards, be sure the cord and plug ends are in good condition. Do not
use an extension cord with conductors smaller than 16 gauge (AWG) in size. To reduce power
loss, use a 14 gauge extension cord if longer than 100 ft.
Any other servicing should be performed by an authorized service representative.
PROPER STORAGE
When the vacuum is not in use, the vacuum and extension cord should be stored indoors
and in a dry place.
WARNING
MOTOR BRUSHES
Only a ProTeam-authorized service or warranty center should replace the carbon motor
brushes or motor. Replacement schedule for motors with replaceable brushes:
1. After the first 800 hours of operation.
2. Again after the next 400 hours of operation.
3. Again after the next 200 hours of operation.
ProTeam
• ONLY TRAINED SERVICE PERSONNEL should per-
form maintenance on the charging system and vacuum.
• UNPLUG the vacuum and DISCONNECT the batteries
when performing any maintenance.
• The following information is for use by qualified service per-
sonnel only, and provides guidance for troubleshooting and
maintenance under normal working conditions.
• UNPLUG the vacuum and DISCONNECT the batteries
when working on the motor or any electrical part.
5
Tabla de contenido
loading

Este manual también es adecuado para:

1060870

Tabla de contenido