Operation
on a thermostat. Press the
J or I buttons to adjust the
set temperature. Once the
desired set temperature is
reached the heater will turn off.
The heater will cycle On and
Off to maintain the desired set
temperature.
Disable Heat
If desired, depending on the sea-
son, the heater on the unit can be
disabled. The unit will operate in
the same fashion, with remainder
of the controls.
To Disable - Press J and O at the
same time. The temperature
setting on the remote will no
longer be visible.
!
NOTE: The heat will not work
in manual controls either.
To Enable - Press J and Q at the
same time. The temperature
setting will now be visible
again.
Figure 5
Unlocked
Child Lock Tab
Locked
Child Lock (Figure 5)
1. Depress tab on the battery
cover on the back of the re-
mote and remove the battery
cover.
2. Move Child Lock tab to the
right to lock the remote control.
3. Move Child Lock tab back to
the left to unlock the remote
control.
4. Replace the battery cover.
!
NOTE: To temporarily unlock
the remote control press (in
order) I then J then K.
When the remote control's back-
light is illuminated the Child Lock
is bypassed. When the backlight
is off the Child Lock is re-activat-
ed.
Frequency Interference
If the fireplace does not respond
properly to the remote control, the
remote operating frequency may
have to be reset. The remote
control can send another fre-
quency code to the circuit board
to eliminate interference.
1. Simultaneously press the O
button and the
remote control.
2. "COD" will appear in place of
Q
button on the
13