ENGLISH
1. GENERAL
1.1 Applications
• Installation of heat transfer in closed circuit by:
- heat exchanging fluids or thermal fluids (mineral oils,
synthesis hydrocarbons).
- pressurized hot water.
• All manufacturing or processing industries:
- chemical, pharmaceutic,
- food, textile, paper, leather,
- rubber, colorants, varnishes,
- solar power (glasshouses, swimming-pools).
1.2 Caractéristiques techniques
•Max. service pressure
•Temperature maxi
Head of water
•Flowrate
•Ports ND
* Version "C": thermal fluids - Version "E": overheated water.
2. SAFETY
Read this data sheet carefully before installing and
starting up. Pay special attention to the points
concerning the safety of the equipment for the
intermediate or end user.
2.1 Symbols used in the manual
Warning.
Instructions concerning electricity.
Calls attention to a potential risk that might
ATTENTION !
affect the safety of people.
Note: installations of heat transfer by heat exchanging
fluids or pressurized hot water imply a special
experience subject to rules aiming at the maximum
safety of such installations.
3. TRANSPORT AND STORAGE
When taking delivery of the equipment, check that it
has not been damaged in transport. If any damage is
noted, take the necessary steps with the carrier within
the allowed time.
If the equipment delivered is to be installed at a
later time, store it in a dry place and protect it
from damage and outside influences (moisture, frost,
etc.).
GET C* : 9 bar
GET E* : 23 bar
GET C : 350 °C
GET E : 210 °C
: untill 40 m
: untill 65 m 3 /h
: 20 to 80
Note: in case of a prolonged stop and in the absence
of frost, leave the pump full of water, or drain the
pump.
4. PRODUCTS AND ACCESSORIES
4.1 The pump
• Monobloc, mostage centrifugal pump, pump casing
with PN25 flanges.
• Cooler with blades built in the bottom.
• Wheel mounted directly on the motor shaft.
• Pump-motor link through spacer.
• The shaft opening is made tight by a mechanical
seal.
Two versions:
GET C: thermal fluids
GET E : overheated water.
4.2. The motor
Lengthened shaft end.
• Speed
• Winding three
• Frequency
• Insulation class
• Protection index
4.3.Accessories (optional)
• Motor 60Hz - 4 poles and 2 poles • Pressure gauge kit
• Motor protection circuit-breaker • Other motor
protection •
5. INSTALLATION
5.1.Room
Install the pump in a place easy to reach, protected
from frost, and as close as possible to the water
drawing point.
By design, the GET group should be installed in
aerated environment, in case of a fairing,
provide for inlet in the lower part and outlet in the
upper part to favour the cooling.
See that "E" (overheated water) or "C" (heat
exchanging fluids) execution well corresponds to the
use of the group.
A reversal would be fatal to the mechanical seal and
the gaskets.
Do not exced the maximum suction head of the
pump.
5.2. Hydraulic connections (see FIG.1)
All mountings are possible, except with the vertical (up
or down) motor.
Direct mounting on piping between two isolation
valves to make its disassembly easier.
The fluid circulation direction is indicated on the pump
casing.
7
: 1450 and 2900 rpm
: 230-400 V
: 50 Hz
: B mini
: IP55