Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Chapter 3 Remote Control
Remote Control via USB
1. Connect the device
Connect the USB DEVICE interface at the rear panel of DG1062Z with your PC
using a USB cable.
2. Install the USB driver
This generator is a USB-TMC device. Assuming that your PC has already been
installed with Ultra Sigma, after you connect the generator to the PC and
turn both on for the first time (the generator is automatically configured to
USB interface), the New Hardware Wizard as shown in the figure below is
displayed on the PC. Please install the "USB Test and Measurement Device
(IVI)" driver following the directions in the wizard. The steps are as follows.
DG1000Z User's Guide
RIGOL
3-2
Tabla de contenido
