Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Chapter 2 Front Panel Operations
AC Adaptor
1
USB Cable
1
BNC Cable
1
CD-ROM
1
Connect DG1000Z with PA1011:
DG1000Z
When the connection between DG1000Z and PA1011 as shown in the figure above
succeeds, pulse Utility → PA Set at the front panel of DG1000Z to enter the PA
parameters setting interface.
1. Switch
Turn "On" or "Off" the external power amplifier. If "On" is selected, the PA
amplifies and then outputs the input signal (namely the output signal of the
signal generator); if "Off" is selected, the PA has no output.
2. Gain
Select "X1" or "X10" as the amplifier gain of the signal output from the PA.
"X1" means output without gain and "X10" means to amplify the signal 10
times and then output.
3. Output
Select "Normal" or "Invert" output mode for the signal output from the PA. Pay
attention to distinguish it with "Output Polarity" of DG1000Z.
4. Offset
Turn "On" or "Off" the output deviation for the output from the PA. When "On"
is selected, use the numeric keyboard or direction keys and mando to set
deviation value. The available range is from -12V to 12V and the default value
is 0V.
5. Store
Store the current working state of the PA in its internal memory. When the PA
is turned on the next time, it will automatically recall the stored working state.
TIP:
DG1000Z User's Guide
Output 12V, 4A signal.
Connect PA1011 with DG1000Z.
Connect PA1011 with DG1000Z.
Provide the PC software installation program of PA1011.
Output
BNC Cable
USB Host
USB Cable
Input
PA1011
USB Device
Output
RIGOL
2-112
Tabla de contenido
