Functions Of The Key; Switching Off; Deactivate / Activate Auto Off; Functions Of The Filter Key - Chauvin Arnoux MH 60 Manual De Instrucciones

3.1. FUNCTIONS OF THE
3.1.1. SWITCHING ON
Long-press the
. The «ON» state of the MH 60 clamp is indicated by the sequential lighting of the «BAT» LED.

3.1.2. SWITCHING OFF

Long-press the
of the LED, then all of the LEDS. When the key is released, the MH 60 clamp switches off.

3.1.3. DEACTIVATE / ACTIVATE AUTO OFF

Reminder: Each time the device is switched on (by pressing
If operation is interrupted because the storage battery charge is too low, the current state of the AUTO
OFF function is stored, then restored when the power supply is restored.
Start from the following state: the MH 60 clamp is «ON».
Hold the key down and press
Keep it pressed (approx. 2 s) until acknowledged, then rapid blinking of the
Release the
The LED stop blinking → The AUTO OFF function is deactivated.
To reactivate , proceed in the same way or switch On/Off using
Remarks: The «AUTO OFF» timer is reset whenever one of the keys is pressed.
The Auto Power Off hold-off time is approximately 10 mn.

3.2. FUNCTIONS OF THE FILTER KEY

3.2.1. CHANGE THE FILTER

A short press on the
or the 30 kHz LED that lights (green LED). If both LEDs are off, it means that it there is no filter.
The state of the filter is stored. It is restored at each power up.
key. The clamp MH 60 acknowledges with the LED
key (2 s). The MH 60 clamp acknowledges the long press by the rapid blinking
and keys.
key changes the filter. Depending on the filter chosen, it is the 3 kHz LED
KEY
.
22
LED. Then release
), AUTO OFF is active.
LED.
.