KitchenAid 5KPM5C Manual De Instrucciones página 6

OFF
TO ATTACH BOWL
• Be sure speed control is OFF.
• Tilt motor head back.
• Place bowl on bowl-clamping plate.
• Turn bowl gently in clockwise direction
(see picture above).
• Sit pouring shield on bowl.*
* If Pouring Shield is included
TO REMOVE BOWL
• Turn speed control to OFF.
• Tilt motor head back.
• Turn bowl in counterclockwise direction.
TO ATTACH FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
• Turn speed control to OFF and unplug.
• Raise motor head.
• Slip beater onto beater shaft and press
upward as far as possible.
• Turn beater to right, hooking beater
over pin on shaft.
TO REMOVE FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
• Turn speed control to OFF and unplug.
• Raise motor head.
• Press beater upward as far as possible and
turn left.
• Pull beater from beater shaft.
ON
TO LOCK MOTOR HEAD IN RAISED POSITION
• Push locking lever into UNLOCK position
• Tilt motor head back.
• Move locking lever into LOCK position.
TO LOCK MOTOR HEAD IN OPERATING
POSITION
• Push locking lever into UNLOCK position
• Lower motor head until it is completely
• Move locking lever into LOCK position.
• Before mixing, test motor head lock by
NOTE: Motor head should always be kept
in LOCK position when using mixer.
TO OPERATE CONTROL SPEED
• Speed control lever should always be set
6
and hold.
and hold.
down into operating position.
attempting to raise head.
on lowest speed for starting, then gradually
moved to desired higher speed to avoid
splashing ingredients out of bowl. See
"Speed Control Guide."