To Attach The Product To The Concrete Form; To Attach The Product With Bolts; Installation; To Attach The Product With Brackets - Husqvarna ER 105 Manual Del Usuario

• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
• Clean the product to remove dangerous material
before you do the maintenance.
•
Disconnect the product from the power source
before you do the maintenance.
• Do not change the product. Modifications that are
not approved by the manufacturer can cause serious
injury or death.
• Always use original accessories and spare parts.
Accessories and spare parts that are not approved
To attach the product to the concrete
form
1. Make sure that the surface of the concrete form is
flat, clean and not painted.
2. Make sure that the concrete form is rigid. If the
concrete form is not rigid, it must be made stronger
with a welded plate.
3. Attach the product to the concrete form or to the
welded plate with bolts or brackets. Refer to
attach the product with bolts on page 7 and To
attach the product with brackets on page 7 .

To attach the product with bolts

1. Attach the product directly to the concrete form or to
the mounting plate that is welded onto the concrete
form. Tighten the bolts to the correct torque. Refer to
Tightening torque on page 19 .
CAUTION: Make sure that the bolts are
locking screws and made of high
resistance steel. The bolts must be of
strength class 8.8 or 10.9.
2. Do a check of the tightening torque after the first 30
minutes of operation and then after each 100 hours
of operation.
1586 - 001 - 26.03.2021
by the manufacturer, can cause serious injury or
death.
• Replace damaged, worn or broken parts.
• Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
• If the replacement of the supply cord is necessary,
this has to be done by the manufacturer or his agent
in order to avoid a safety hazard.
• After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
• Let an approved service agent do servicing on the
product regularly.

Installation

To attach the product with brackets

C
To
Bracket
A
B
A
Order No. Normal frequency (3000
rpm 50Hz and 3600 rpm
60 Hz)
594367701 ER 305. The bracket must
be welded to the struc-
ture.
597267501 ER 405 and ER 505. The
bracket kit includes brack-
et (A), a mounting plate
and a set of bolts. The
bracket must be welded to
the structure. Attach the
mounting plate to the
bracket. Attach the prod-
uct to the mounting plate.
B
D
7