Husqvarna ER 105 Manual Del Usuario página 67

2. Push the bearing (A) into the bearing bracket (B)
with a bearing press or a soft head mallet.
B
A
E
3. Put the stator (C) into the bearing bracket. Put the
stator and bearing bracket into the housing.
MISE EN GARDE : Make sure that the
windings in the rotor (D) are not
damaged. Make sure that the seal (E)
and O-ring (F) are not damaged.
4. Assemble the bearing cover (G) with the screws (H).
G
H
1586 - 001 - 26.03.2021
D
C
F
5. Assemble the eccentric weights (I) with the bolt (J)
and the washer (K).
I
K
J
Remarque : Use the note you made to put the
eccentric weights in the correct positions. Refer to
To disassemble the product à la page 66 .
6. Assemble the end cover (L) with the bolts (M) and
the washers (N). Tighten the bolts to the correct
Tightening torque à la page 72 .
torque. Refer to
L
N
M
67