Step 3: Unpacking, Moving And Placing The Range - Thermador PROFESSIONAL PRO GRAND PRD606RCG Instrucciones De Instalación

Refer to Figure 11 on page 17 for location of terminal block
on unit. To minimize binding when the unit is connected to
the receptacle or terminal block, orient the receptacle or
conduit connector, and slide back into position.
When using a receptacle it may be necessary to recess the
receptacle's housing into the rear wall. Refer to Local Electrical Code to determine the minimum volume for all
electrical / junction boxes. Follow all local electrical
codes.
Mount the receptacle securely to a wall stud, then seal
around the receptacle's housing.
STEP 3: Unpacking and
Moving the Range
Unpacking the Range
CAUTION
DO NOT lift the range by the oven door's
handle, as this may damage the door hinges
and cause the door to fit incorrectly.
DO NOT lift the appliance by the range's
control panel.
The unit is heavy and should be handled
accordingly. Proper safety equipment such as
gloves and adequate manpower of at least two
people must be used in moving the range to
avoid injury and to avoid damage to the unit or
the floor.
Rings, watches, and any other loose items that may
damage the unit or otherwise might become entangled
with the unit should be removed.
Hidden surfaces may have sharp edges. Use caution
when reaching behind or under appliance.
DO NOT use a hand truck or appliance dolly on the back
or front of the unit. Handle from the side only.
1. Remove the outer carton and packing materials from
the shipping pallet but leave the adhesive-backed foam
layer over brushed-metal surfaces, to protect finish
from scratches, until the range is installed in its final
position.
Installation Instructions
2. Remove the door(s) (see "STEP 4: Door Removal and
Adjustment" on page 12); however, DO NOT remove
the warming drawer or steam oven doors, if applicable.
This will allow the range to pass through 30" (762 mm)
doorways.
3. The grates, griddle plate, burner caps, and oven racks
must be removed to facilitate handling. DO NOT
remove the griddle element and tray assembly.
Moving the Range
NOTE: DO NOT remove control panel foam until unit is
completely installed. DO NOT lift on the control panel at
any point during the installation.
Due to the weight, it is strongly recommended that a
furniture dolly with soft wheels or an air lift should be used
to move this unit. The weight must be supported uniformly
across the bottom.
1. To remove the pallet bolts in the front and in the back,
use a 7/16'' wrench or ratchet and socket to remove the
pallet bolt from the bottom of the pallet. Discard the
wood packing block inserts.
Figure 5: Removal of Shipping Bolts
2. Carefully tilt the range back on the casters and remove
it from the pallet. Use additional help as required to
remove from pallet.
3. After transporting the range by furniture dolly close to
its final location, the range can then be tipped back and
supported on the rear casters while the dolly is
carefully removed.
4. Use the casters to assist with the installation near to its
final location. THE FLOOR UNDER THE LEGS
SHOULD BE PROTECTED BEFORE PUSHING THE
UNIT INTO POSITION.
• Steps 4 through 8 must be completed before the
range is placed in its final position.
English | 11 |