Step 3: Unpacking, Moving And Placing The Range - Thermador PRG304GH Instrucciones De Seguridad

When the power supply cord is connected to the mating
receptacle, the combined plug/receptacle connection
should protrude no more than 2" (51 mm) from the rear
wall, see Figure 6.
STEP 3: Unpacking and
Moving the Range
CAUTION
DO NOT lift the range by the oven door's
handle, as this may damage the door hinges
and cause the door to fit incorrectly.
DO NOT lift the appliance by the range's
control panel.
The unit is heavy and should be handled
accordingly. Proper safety equipment such as
gloves and adequate manpower of at least
two people must be used in moving the range
to avoid injury and to avoid damage to the
unit or the floor.
Rings, watches, and any other loose items
that may damage the unit or otherwise might
become entangled with the unit should be
removed.
Hidden surfaces may have sharp edges. Use
caution when reaching behind or under
appliance.
DO NOT use a hand truck or appliance dolly
on the back or front of the unit. Handle from
the side only.
Installation Instructions
Figure 6: Wall Connection
Unpacking the Range
1. Remove the outer carton and packing materials from
the shipping pallet but leave the adhesive-backed foam
layer over brushed-metal surfaces, to protect finish
from scratches, until the range is installed in its final
position.
2. It is recommended that the grates, griddle plate, burner
caps and oven racks be removed to facilitate handling.
If desired, the oven doors may also be removed (see
"STEP 8: Door Removal and Adjustment" on page 20).
Do not remove the griddle assembly.
Shipping Weight
Weight without
packing materials
Moving the Range
Due to the weight, a furniture dolly with soft wheels or an
air lift should be used to move this unit. The weight must be
supported uniformly across the bottom.
NOTICE: The electric wire diagrams and schematics are
attached behind the kick panel, and should not be removed
except by a service technician, then replaced after use.
Removing the Pallet Bolts
1. To remove the (4) pallet bolts in the front and in the
back, use a 7/16'' wrench or ratchet and socket to
remove the pallet bolt from the bottom of the pallet.
Discard the wood packing block inserts.
Figure 7: Removal of Shipping Bolts
30" 36"
RANGE RANGE RANGE
372 lbs 419 lbs 565 lbs
(169 kg) (190 kg) (256 kg)
290 lbs 310 lbs 421 lbs
(132 kg) (141 kg) (191 kg)
Table 1: Range Weight
English 12
48"