Electrical Supply; Step 3: Unpacking, Moving And Placing The Range - Thermador PRO-HARMONY PRG30 Manual De Instalación

Important:
The cord supplied with the gas ranges, having an electric
griddle, requires a NEMA 5-20 receptacle, shown here.
Local codes may require a different wiring method.
NEMA 5-20
RECEPTACLE

Electrical Supply

Installation of the range must be planned so that the rough-
in of the junction box for the receptacle will allow maximum
clearance to the rear of the unit. To minimize binding when
the unit is connected to the receptacle or junction box,
orient the receptacle and slide back into position.
When the power supply cord is connected to the mating
receptacle, the combined plug/receptacle connection
should protrude no more than 2-1/2" from the rear wall. See
Figure 3b.
Power Cord & Receptacle
English 8
PLUG
2-1/2" maximum
when plugged in
Figure 3b: Wall Connection
Step 3: Unpacking, Moving
and Placing the Range
CAUTION
Proper equipment and adequate manpower
must be used in moving the range to avoid
injury, and to avoid damage to the unit or the
floor. The unit is heavy and should be handled
accordingly.
• The range has an approximate shipping weight as
shown in Chart A. The grates, griddle plate and frame,
burner caps, front kick panel and oven racks must be
removed to facilitate handling. This will reduce the
weight as shown in Chart A. See Figure 2 on page 6.
Do not remove the griddle assembly.
• Remove the outer carton and packing material from the
shipping base. The all gas ranges are held to the pallet
by four (4) bolts (see Figure 4). After removing the
bolts, the range must be lifted and removed from the
pallet.
Important:
DO NOT lift the range by the oven door's handle, as this
may damage the door hinges and cause the door to fit
incorrectly to the oven cavity.
Chart A
Shipping Weight
Weight without packing
materials
Without door(s), burner
caps, front kick panel and
oven racks
30" Range 36" Range
300 lbs. 335 lbs.
265 lbs. 300 lbs.
142 lbs. 207 lbs.