Operation - Sirona Dental SIROTorque L+ Manual Del Operador

Sirona Dental Systems GmbH
Operating Instructions SIROTorque L
5

Operation

t a l t a l
e n e n s t r s t r
a D a D
r ik r ik
o n o n
F a b F a b 5 B 5 B
S ir S ir 6 2 6 2
6 4 6 4
r m r m
D - D - G e G e
61 74 499 D 3489
D 3489.201.02.02.02
+
10
) )
0 V 0 V
(2 3 (2 3
) )
0 V 0 V
M M
- 0 2 - 0 2 (1 2 (1 2
E 2 4 E 2 4 2 M 2 M
4 - 0 4 - 0
T IY T IY
M 2 M 2
T IY T IY
2 3
0 1
5
H H
m b m b
s G s G
t e m t e m
S y s S y s
1 1
e 3 e 3
a ß a ß
im im
s h e s h e
e n e n
y y
a n a n
ATTENTION
Make sure that the compressed air is always dry, clean
and not contaminated. Dirty or humid compressed air
leads to premature wear of the motor.
Permissible speed range: 90 – 40,000 rpm
The compressed air emitted at the highspeed handpiece
hose connection piece should have a pressure
of at least 44 psi (3 bar) to enable the electric motor to
reach its maximum speed.
ATTENTION
The displayed speed is an approximate value. The actual
speed may differ from the displayed speed.
If you need an accurate speed, you should operate the
motor at a speed close to 40,000 rpm and use the
corresponding contra-angle handpieces.
e.g. desired speed: 347 rpm.
– Set motor to 40,000 rpm
– Use reduction gear instrument (115 : 1).
Switch the unit on
with the ON/OFF switch (10) on the rear side of the unit.
The display lights up and the settings of the last
handpiece used appear (even if they deviate from the
stored values).
ATTENTION
This unit offers a higher power output than a highspeed
handpiece. You should practice treatment on a phantom
element before using it on a patient.
5 Operation
13