Entering Your Security Code; Locking The Safe - STACK-ON TDS-42-SG-E-S Manual De Instrucciones

ENTERING YOUR SECURITY CODE

To enter your own security code you will need
to follow the steps listed below:
1. After opening the electronic safe (with the
preset factory code of 1 - 5 - 9 - # locate the
small red reset button on the inside of the door
near the hinge.
2. Press the red reset button and then release
it, you will hear a beep. The yellow light on the
faceplate will be activated and will stay on for a
period of time that should allow you to enter
your code. You can only enter your code while
the yellow light is on.
With the door open and the yellow light on,
enter your own personal security code, which
can be 3 - 8 digits long, and confirm your new
code by pressing the "
electronic touch pad. Before you close the
door, try the new security code to make sure
the lock releases the handle so you can turn it
and retract the live action bolts.
DO NOT SHUT THE DOOR UNTIL YOU HAVE
CONFIRMED THAT YOUR NEW SECURITY CODE
HAS BEEN ENTERED AND WORKS CORRECTLY.
To open the safe, first press any key to activate
the keypad, then enter the security code you
have set followed by the "
If the code fails, go through steps 1 and 2 again.
If the code works successfully record your
combination number on the front of this form or
store your combination on our secure website at
stackon.com under Customer Service. If you
write down your combination you must keep this
information in a secure place, away from
children, not inside the safe. Then you should
close and lock the safe.
If the incorrect security code is entered
3 times you will have an automatic lockout for
15 seconds before you can try your code again.
If the incorrect code is entered 2 additional
times you will have a 5 minute lockout before
you can try your code again.
NOTE: If you press the wrong number while
entering a security code, you can press "
to erase that entered number.
" symbol on the
#
" symbol.
#

LOCKING THE SAFE

To lock the safe, close the door and rotate the
handle counter clockwise until it stops. If the
handle is not turned until it stops, the locking
mechanism will not lock.
NOTE ON LOCKING THE SAFE: Because the
locking mechanism is deactivated for
approximately 3 to 6 seconds after the
combination is entered, wait a minimum of
6 seconds from the time the combination is
entered to lock the safe.
BACK UP KEY
A "Back Up Key" has been provided in case you
have forgotten or lost your security code. To
open the safe using the back up key follow the
steps below:
1. Remove the lock face by pressing the tab and
turning the lock face as shown in the
illustration. The lock can hang by the
connecting cable while unlocking the safe.
2. Insert the key in the key hole and turn
clockwise 1/4 turn (until stopped) in order to
unlock the safe. Rotate the handle and open
the door.
3. Keep the door open until you have entered a
new security code. Before entering your new
code, remove the key and screw the cover back
in place.
4. Enter your new security code following the
instructions for entering your security code.
"
TAB
3
14
40828-1806