STACK-ON TDS-42-SG-E-S Manual De Instrucciones página 5

SECURING THE SAFE
NOTE: This safe must be secured to the floor.
Use the hardware provided.
NOTE: This safe must be mounted to the floor.
Failure to do so will compromise the safety and
security of the safe.
WARNING: Because this safe is
waterproof it will float if not
secured. As the water level rises,
the safe will begin to float and could
fall over causing personal injury.
The safe must be fastened to the floor using
the lag bolts and gasket washers provided
with this safe to insure the waterproof
rating. Failure to do so will void the
waterproof rating.
IMPORTANT: You must remove the safe from
the skid/legs and place the safe on the floor.
Failure to do so will void the fire and
waterproof ratings.
Place the safe in the desired location. When your
safe is open, lift the carpeting up and locate the
mounting hole bushings. These bushings are
filled with fire resistant caulking which must be
drilled out before mounting the safe to the floor.
Use a 3/8" diameter drill bit to drill out this
caulking. Continue to use this drill to mark the
hole location on the floor. Move the safe away.
Drill pilot holes in the floor as follows: For a
wood floor drill 5/16" diameter x 2-1/2"
deep pilot holes. For a masonry floor drill 7/16"
diameter x 2-1/2" deep pilot holes for
the anchors.
IMPORTANT: When you drill out the fire
resistant caulking from the mounting holes,
you must mount the safe to the floor using the
lag bolts and gasket washers. Failure to do so
will void the fire rating and waterproof rating.
Reposition the safe and secure the safe with
the lag bolts and gasket washers. Replace
the carpeting.
GUN REST INSTALLATION
Gun rests are pre-installed with (4) L brackets
using (2) screws for each bracket. The gun rest
should be permanently secured to avoid shifting
when accessing your guns.
Gun rests can be adjusted by removing the
L brackets and securing them at a different
height location. See Figures 1 and 2 below, for
reattaching the brackets. The gun rest should be
level after assembly.
SHELVES
The shelves can be installed by locating the shelf
clips to the desired location and setting the
shelf in place.
DOOR ORGANIZER ACCESSORIES
Your door organizer provides a variety of storage
options for your supplies.
Note: Make sure the door accessories do not
interfere with items in the safe or when closing
the safe door.
1
1
2
2
Image does not
necessarily
reflect the
configuration of
your safe.
40828-1806
5
14