ResMed AirFit F20 Guia Del Usuario página 11

Ocultar thumbs Ver también para AirFit F20:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 75
CAUTION
Visible criteria for product inspection: If any visible
deterioration of a system component is apparent (cracking,
discoloration, tears etc.), the component should be
discarded and replaced.
Daily/After each use:
1. Disassemble the mask according to the disassembly
instructions.
2. Rinse the frame, elbow and cushion under running water.
Clean with a soft brush until dirt is removed.
3. Soak the components in warm water (approximately
86°F/30°C) with a mild liquid detergent for up to ten
minutes.
4. Shake the components vigorously in the water for at least
one minute.
5. Brush the moving parts of the elbow and around the vent
holes.
6. Brush the areas of the frame where the arms connect, and
inside and outside the frame where the elbow connects.
7. Rinse the components under running water.
8. Leave the components to air dry out of direct sunlight.
Make sure to squeeze the arms of the frame to ensure
that excess water is removed.
Weekly:
1. Disassemble the mask. The magnets can remain attached
to the headgear during cleaning.
2. Handwash the headgear in warm water (approximately
30°C) with mild liquid detergent.
3. Rinse the headgear under running water. Inspect to
ensure the headgear is clean and detergent free. Wash
and rinse again, if necessary.
4. Squeeze the headgear to remove excess water.
5. Leave the headgear to air dry out of direct sunlight.
Cleaning your mask at home (AirTouch F20)
It is important to follow the steps below to get the best
performance out of your mask. It is recommended to replace
your cushion every month.
WARNING
As part of good hygiene, always follow cleaning
instructions. Some cleaning products may damage the
mask, its parts and their function, or leave harmful
residual vapours that could be inhaled if not rinsed
thoroughly.
Regularly clean your mask and its components to
maintain the quality of your mask and to prevent the
growth of germs that can adversely affect your health.
CAUTION
Visible criteria for product inspection: If any visible
deterioration of a system component is apparent
(cracking, discoloration, tears, etc.), the component
should be discarded and replaced.
The cushion must not be submerged in liquid as this
may damage the cushion and affect mask
performance.
4
Tabla de contenido
loading

Este manual también es adecuado para:

Airtouch f20

Tabla de contenido