Parkside ZKGS 2100 Instrucciones De Utilización Y De Seguridad página 40

Anleitung_4300689:_ 24.11.2009
GB/
MT
and do not use the cable to pull the plug out
of the socket. Protect the cable from heat,
oil and sharp edges.
Secure your workpiece
- Use clamps or a vise to hold the workpiece
securely. This is safer than using your hand
and also enables you to operate the
machine with both hands.
Do not overstretch.
- Avoid abnormal working postures. Make
sure you stand squarely and keep your
balance at all times.
Take care of your tools
- Keep your tools sharp and clean in order
to work well and safely. Follow the
maintenance information and the
instructions for changing tools. Check the
power plug and cable on a regular basis
and have them replaced by an authorized
specialist if they are damaged. Check the
extension cable regularly and replace it if
damaged. Keep handles dry and free from
oil and grease.
Pull the power plug
- When tools are not in use, before starting
any maintenance work or when changing
attachments such as saw blades, drill bits
and all kinds of mounted tools.
Always remove keys and wrenches after
use
- Before switching on, make sure that all
keys and wrenches have been removed
from the tool.
Avoid unintentional starting
- Never carry a tool with your finger on the
switch button while the tool is connected to
the power supply. Make sure that the switch
is turned off when connecting the tool to the
power supply.
When using an extension cable
outdoors
- Check that it is approved for outdoor duty
and is marked accordingly.
Be alert at all times
- Keep an eye on your work. Use common
sense when working. Never use the tool
when you are distracted.
Check the equipment for damage
- Before using the tool again, check the
safety devices or any slightly damaged
40
16:21 Uhr Seite 40
parts to ensure that they are in good
working order. Check that the moving parts
are working correctly, that they do not jam,
and that no parts are damaged. Make sure
that all parts are fitted correctly to ensure
that the equipment remains safe to use.
Unless otherwise stated in the operating
instructions, damaged guards and parts
have to be repaired or replaced by a
customer service workshop. Damaged
switches have to be replaced by a customer
service workshop. Never use an electric
power tool with a switch that cannot be
turned on and off.
Important!
- For your own safety you must only use the
accessories and additional units listed in the
operating instructions or recommended or
specified by the manufacturer. The use of
mounted tools or accessories other than
those recommended in the operating
instructions or catalog may place your
personal safety at risk.
Repairs may only be carried out by a
qualified electrician
- This electric power tool complies with the
pertinent safety information. Repair work
must only be carried out by a trained
electrician, otherwise the equipment may
cause accidents.
Connect up a vacuum extraction system
- If there are provisions for connecting up a
vacuum extraction system, make sure that
such a system is fitted and in use.
2.3 Special safety information on the
equipment
1. Safety precautions
Change a worn out table insert.
Use only blades which are recommended
by the manufacturer and comply with EN
847-1.
If necessary, wear suitable personal
protection equipment. This could consist of:
- Ear plugs to prevent the risk of damaging
your hearing
- A breathing mask to avoid the risk of
inhaling hazardous dust
- Always wear gloves when handling saw