Milnor MilTouch-EX 48040H7K Guía Del Operario página 34

Chapter 2. How to Configure and Program the Control
Mildata
2.1.35.
Set whether this machine is part of a Mildata network.
Mildata Address
2.1.35.1.
Formula
—Set whether this machine will pass formula data for each load to the Mildata
2.1.35.2.
computer.
Work Order
—Set whether this machine will pass the work order for each load to the Mildata
2.1.35.3.
computer.
Goods Code
—Set whether this machine will pass the goods code for each load to the Mildata
2.1.35.4.
computer.
Customer
—Set whether this machine will pass the customer code for each load to the Mildata
2.1.35.5.
computer.
Employee
—Set whether this machine will pass employee data for each load to the Mildata
2.1.35.6.
computer.
Weight
—Set whether this machine will pass weight data for each load to the Mildata computer.
2.1.35.7.
Pieces
—Set whether this machine will pass the number of pieces for each load to the Mildata
2.1.35.8.
computer.
Lot
—Set whether this machine will pass the lot number for each load to the Mildata computer.
2.1.35.9.
Digital-to-Analog Offset
2.1.36.
Set this value to calibrate the digital-to-analog board to the inverter for basket speed.
Staged RPM
2.1.37.
Set the maximum allowed speed in RPMs for the first phase of a staged extract step.
Staged Delay
2.1.38.
Set the duration in seconds of the first phase of a staged extract step.
BICLUP01 (Published) Book specs- Dates: 20170301 / 20170301 / 20170301 Lang: ENG01 Applic: CLW
2.2. MilTouch-EX
Type
2.2.1.
End Formula—The formula is completed and causes the controller to query for how to stop the
formula.
1-Way Wash—a bath step in which the cylinder turns in one direction
2-Way Wash—a bath step in which the cylinder turns in the two directions
PELLERIN MILNOR CORPORATION
—Set the machine address on the Mildata network.
— End of BICLWC01 —
™
Wash Formula Decisions
30