Milnor MilTouch-EX 48040H7K Guía Del Operario página 12

Table of Contents
2.3. How to Calibrate the Flow Meter
2.3.1. Application
2.3.2. Preparation
2.3.3. Procedure
2.4. Using Programmable Outputs
Chapter 3. Troubleshooting
™
3.1. MilTouch and MilTouch-EX
BICLUT03)
3.1.1. Messages that Can Occur on All Models
3.1.1.1. Door Opened (1)
3.1.1.2. Vibration Switch Tripped
3.1.1.3. Too Much Water
3.1.1.4. Too Long to Fill (3)
3.1.1.5. Too Long to Drain (4)
3.1.1.6. 3-Wire Circuit Disabled (5)
3.1.1.7. Too Long to Steam (6)
3.1.1.8. Too Long to Cool (7)
3.1.1.9. Check Temperature Probe (8)
3.1.1.10. Level Still Made (9)
3.1.1.11. Serial Communication Failure (10)
3.1.1.12. Failed Speed Sensor (11)
3.1.1.13. Inverter Tripped (12)
3.1.1.14. External Fault Error (13)
3.1.1.15. Brake Pressure Fault (14)
3.1.1.16. Bearing Pressure Fault (15)
3.1.2. Messages that Can Occur on MilTouch-EX
3.1.2.1. Spotting in Progress (19)
3.1.2.2. Brake Pads Worn (20)
PELLERIN MILNOR CORPORATION
Sections
(Document BICLWC02)
(Document BICLWP02)
™
Error Messages
™
8
Figures, Tables, and Supplements
Supplement 4: Common Unit Conversions
Figure 29: Calibration by Weight
Figure 30: Configure button
Figure 31: Flow meter button
Figure 32: Flow Meter Calibration screen
Figure 33: Water Quantity screen
Figure 34: Access to the Programmable
Outputs Display
Figure 35: Programmable Outputs Display
Figure 36: Formula Number Data Entry
Display
Figure 37: Programmable Outputs Display
Figure 38: Programming Display for
Programmable Outputs
(Document
Figure 39: Transducer Tube at Processor
Board
Figure 40: Schematic of Typical Drain
Circuit
Models Only