Tabla de contenido
Idiomas disponibles
Idiomas disponibles
8 Putting out of operation
8 Putting out of operation
9 Maintenance and cleaning
EN - 16
NOTICE
• Please observe the required gas post-flow time for cooling the torch.
• When starting the pilot arc, the cutting nozzle must not be in contact with
the workpiece.
• The cutting arc is ignited on the workpiece. The cutting beam is
interrupted as soon as contact with the workpiece is lost.
NOTICE
• When putting the system out of operation, ensure that the procedures for
switching off each of the welding system components are observed.
• To prevent the inadvertent ignition of the pilot arc, make sure that the
trigger guard on the handle is working perfectly.
1 Close the compressed air valve.
2 Switch off the power source.
Scheduled maintenance and cleaning are prerequisites for a long service life
and trouble-free operation.
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance,
servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close the gas supply.
• Disconnect the mains plug.
NOTICE
• Maintenance and cleaning work may only be carried out by qualified
personnel (in Germany see TRBS 1203).
• Always wear your personal protective equipment when performing
maintenance and cleaning work.
1 Check that all threaded fittings are tight and inspect wear parts for visible
damage. Replace if necessary.
ABICUT 155
Tabla de contenido
