Tabla de contenido
Idiomas disponibles
Idiomas disponibles
8 Putting out of operation
8 Putting out of operation
9 Maintenance and cleaning
EN - 16
NOTE
®
• As the ABIPLAS
putting out of operation depends on the robot control system. Please
make sure that the shutdown procedures for all components integrated in
the welding system are strictly observed.
1 Switch off main current and pilot current.
2 Switch off the power source.
3 Close the shut-off valves for the gas supply.
Scheduled maintenance and cleaning is a prerequisite for a long life and a
trouble-free operation.
DANGER
Risk of injury due to unexpected start-up
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power source.
• Close off the gas supply.
• Close off the compressed air supply.
• Pull the mains plug.
DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation.
• Replace any damaged, deformed or worn parts.
NOTE
• The maintenance intervals given are standard values and refer to single-
shift operation.
• Maintenance and cleaning work may only be carried out by qualified
and trained specialists.
• Always wear your personal protective clothing when performing
maintenance and cleaning work.
WELD 250 MT is integrated into a welding system,
®
ABIPLAS
WELD 250 MT
Tabla de contenido
