Operating The Baby Unit; Switching The Baby Unit On And Off; Indicator Leds - NUK Eco Control Video Display 550VD Manual Del Usuario

the device fails to detect a sound from your
baby for more than 20 seconds.
Note: At VOX level 5, the device is set to
continuous transmission. There is no Eco-
Mode at this level.
The connection indicator 20 flashes green
while Eco-Mode is active.
The screen will
transmission is deactivated.
The appropriate symbol is shown
in the status bar in place of the
symbol that indicates the received
signal strength.
Deactivating Eco-Mode
Eco-Mode is deactivated when:
• your baby makes a sound that exceeds
your set sound limit (VOX level)
• you increase the VOX level setting to 5
(continuous
"6.8 Setting the VOX sensitivity level" on
page 62)
• you use the talk-back function (see
"6.15 Talk-back function" on page 72)
• you activate
"6.11 Lullabies" on page 67)
Note: If VOX level 1 is set and the
lullabies are played at the lowest volume
setting, Eco-Mode can still be activated,
as the lullabies will not exceed the set
sound limit.
• you switch
"5.5 Nightlight" on page 54)
5.1 Switching the baby unit on
and off
The baby unit 1 will switch on automatically
as soon as you have connected the mains
adapter and plugged it into the power
supply. You can then switch the baby unit
off and back on as required.
• To switch the baby unit 1 on or off, press
and hold the On/Off button 10 until the
power LED 8 lights up or switches off.
be white, as
transmission)
the lullabies
the nightlight on

5. Operating the baby unit

• you briefly press the On/Off button 10
When Eco-Mode is deactivated:
• the connection indicator 20 will show a
steady green light
• video and sound transmission will be
active again
• the status bar will show the received
video
signal strength symbol again instead of
the Eco-Mode symbol
Full-Eco-Control
The Full-Eco-Control function maintains the
connection between the parent unit and the
baby unit at all times, so that sounds, video,
and warnings (e.g. temperature alarm) can
be transmitted by the baby unit when
necessary.
The Full-Eco-Control function guarantees
that you and your baby are always
connected. Even when ECO mode is
(see
activated, the baby unit will perform a link
check every 30 seconds to make sure that
the parent unit is still nearby and maintain
the connection between the two units.
If you are out of range at any time, the
(see
parent unit will indicate this by changing the
colour of LED 20 to red and beeping.
A red warning symbol will appear on
the screen.
Note: Check the range of your baby monitor
before using it.
(see

5.2 Indicator LEDs

• The Power LED 8 lights up green while
the baby unit is switched on.
• The VOX LED 7 on the baby unit lights up
green when there is an established
connection between it and the parent unit.
• The VOX LED 7 will not be lit while the
baby unit 1 is switched to Eco-Mode or if
it was not possible to set up a connection
to the parent unit.
53