Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OPERATING PRECAUTIONS
This is a Natural Gas, direct-fired, convection heater. It's intended
use is primarily temporary heating of buildings under construction,
alteration or repair.
If natural gas leaks from a connection or fitting, it can mix with
the surrounding air, forming a potentially explosive mixture.
Obviously, natural gas leaks should be avoided, so set up the
fuel supply with utmost care. Leak check new connections or
re-connections with a soap and water solution and follow all
connection instructions herein. Also, ask your natural gas dealer
for advice on the application and supply installation and ask them
to check it if there are any questions.
This heater was designed and certified for use as a construction
heater in accordance with ANSI Standard Z83.7/CGA 2.14-
201 1. Check with your local fire safety authority if you have any
questions about your applications. Other standards govern the use
of fuel gases and heat producing products in specific applications.
Your local authority can advise you about these.
Direct-Fired means that all of the combustion products enter the
heated space. Even though this heater operates very close to 100
percent combustion efficiency, it still produces small amounts of
carbon monoxide. Carbon monoxide (called CO) is toxic. We can
tolerate small amounts but not a lot. CO can build up in a heated
space and failure to provide adequate ventilation could result in
death. The symptoms of inadequate ventilation are:
•
headache
•
dizziness
•
burning eyes and nose
•
nausea
•
dry mouth or sore throat
So, be sure to follow advice about ventilation in these operating
instructions.
When the heater is to be operated in the presence of other
people the user is responsible for properly acquainting those
present with the safety precautions and instructions, and of
the hazards involved.
SAFETY PRECAUTIONS
1.
Check the heater thoroughly for damage. DO NOT
operate a damaged heater.
2.
DO NOT modify the heater or operate a heater which has
been modified from its original condition.
3.
DO NOT light or operate heater unless the shells are fully
extended and locked into position.
4.
Use only natural gas.
IMPORTANT Use only the regulator assembly provided
5.
with the heater. Inspect regulator assembly before each
use of the heater. If there is excessive wear, or damage
replace with regulator assembly listed on parts list before
using heater.
6.
For indoor or outdoor use. Adequate ventilation must be
provided Figure 1. (Also see "Operating Precautions").
7.
If at any time gas odor is detected, IMMEDIATELY
DISCONTINUE operation until the source of gas has
been located and corrected.
8.
Install the heater such that it is not directly exposed to
water spray, rain and/or dripping water.
3
Convection Construction Heater
9.
Maintain minimum clearance from normal combustible
material (like paper). Figure 2.
10. Due to the high surface and exhaust temperatures, adults
and children must observe clearances to avoid burns or
clothing ignition.
11. Operate only on a stable, level surface.
12. Do not use with duct work. Do not restrict inlet or exit.
13. Do not move, handle or service while hot or burning.
14. Use only in accordance with local codes or, in the
absence of local codes, with the Standard for the Storage
and Handling of Liquefied Petroleum Gases ANSI/
NFPA 58 and CSA B149.1, Natural Gas and Propane
Installation Code.
Figure 2
MINIMUM CLEARANCE: From normal combustible material
HS100CVNG
Clearance
From sides ..................................................4 ft
From top .....................................................6 ft
Locate 10' from canvas or plastic tarpaulins or similar coverings
and secure them to prevent flapping or movement due to wind
action.
Operating Instructions and Owner's Manual
Convection
Tabla de contenido
