Tabla de contenido
INSTALL THE SUPPORT BRACKETS
1. Find the left and right T-slot bracket kits. Figure A indicates
the proper orientation of the left and right brackets at the
head end of the frame.
Footbar End
Standing platform
T-slot bracket assembly-left
Fig A
2. Loosen the four screws on each bracket until all the plates of
the bracket are completely loose. The bracket is held together
with "capture screws" and will not fall apart.
3. Fit the bottom of the inner plate of the bracket into the
bottom edge of the Allegro frame. See Figure B.
Fig B
4. Position the bracket so that the inner plate contacts the
Allegro frame. Reinsert the four screws into the Tower bracket.
Using the Allen key, turn each screw a few times. When all
four screws are engaged, slide the entire assembly until the
edge of the inner plate touches, but does not cover, the corner
screw. See Figure C
T-slot bracket
assembly-right
Fig C Outer Plate cut away to clearly
show corner screw.
Head - End
5. Insert a black knob through the bracket and into the inner
plate. Do not tighten. This knob will act as a support bolt for
the bottom of the Tower. Tighten all 4 bracket screws securely.
Repeat on the other side.
ATTACH THE TOWER OF POWER FRAME
Note: The push through bar should remain secured to the side of
the Tower for this step.
6. Position the Tower at the head end of the Allegro with the
serial number facing outward, away from the frame.
7. Lower the Tower onto the support brackets so the slots at the
bottom of the Tower frame fit over the black knobs.
8. While supporting the Tower, insert the black pivot knobs and
spacers an shown in Figure E. Tighten all black knobs.
Fig E
Corner screw
Fig D
Black knobs
Spacer
Bracket
screws
Slot
Top of
Slot
15
Tabla de contenido
