Operating Modes - Petsafe Microchip Petporte smart flap Guia Del Usuario

Operating Modes

Normal Mode
This is the default mode on powering the cat fl ap and will allow only your cat(s) to enter.
Night Mode
For a variety of reasons, many pet owners prefer their animals not to go outside at night. The Petporte smart fl ap® provides a mode
whereby it will automatically prevent your pet from going outside during hours of darkness and the cat fl ap will automatically unlock
when daylight dawns. If your pet is already outside when darkness falls, the system will still allow the animal to enter.
The Night Mode also allows pet owners to set the specifi c time of day that they want the unit to lock and unlock (Timer Mode).
To employ this mode, press the Red button for less than 2 seconds and then release it. The unit will beep and the red light will il-
luminate to inform you that it is in Night Mode (Timer Mode).
• At the pre-set LOCK time or when darkness falls, the green light will illuminate, indicating that the cat fl ap will be locked.
• At the pre-set UNLOCK time or when dawn arrives, the green light will extinguish, indicating that the cat fl ap will be unlocked.
Note: Night mode can take up to 30 seconds to start functioning.
Vet Mode
If you are intending to take your pet to the vet, or just want it to stay inside, then the Petporte smart fl ap
your cat can enter but will not be allowed out again.
To employ this mode, press the Red Button for 5 seconds, or until the red light begins to fl ash, and then release it. The unit will then
beep and the red light will start to fl ash, indicating that the cat fl ap is locked and your cat cannot go out.
To exit this mode, press the Red Button again for 5 seconds, or until the red light begins to fl ash, and then release it. The unit will
beep again and the red light will extinguish.
Extended Modes
The Petporte smart fl ap ® has a number of extended modes that allow you to customise the Petporte smart fl ap
For information on how to use the Extended Modes please see the Extended Modes section on page 19 of this user guide.
Key Pad Lock
If you wish to lock the buttons on your Petporte smart fl ap
and hold the Red Button for 30 seconds. The unit should begin to beep repeatedly. Release the Red Button and the unit will be set
to Key Pad Lock.
To re-enable the button controls and disable the Key Pad Lock, repeat the above process.
Erase Mode
If you wish to erase all programmed animal identifi cation numbers from the system's memory, please use the following procedure.
However, it must be noted that once the memory has been erased, you will have to re-program the unit with any animals that are to
use the cat fl ap. Therefore, please ensure that you really wish to erase the memory before proceeding.
To erase all microchip numbers, press and hold both the Red and Green Buttons for 30 seconds. The unit should begin to beep
repeatedly. Release both the Red and Green buttons and the unit should emit a long beep and both lights should begin to fl ash,
indicating that the memory has been erased.
Note: Once the unit's memory has been erased, it will have to be re-programmed before further use!
Reset to Normal Mode
Should you wish to reset your Petporte smart fl ap
Open Mode, please use the following procedure.
Press and hold the Green Button for more than 30 seconds, or until the unit emits a series of short beeps, before releasing the
button. The unit should emit a long beep and all lights should extinguish, indicating the Petporte smart fl ap
Mode of operation. Returning to Normal Mode will not erase your cat's programmed microchip numbers or the variable functions
available in the Extended Modes.
® (this is helpful in preventing children from adjusting the modes), press
®
back to its Normal Mode and exit modes such as Night Mode, Vet Mode or
® provides a mode whereby
® to suit your individual needs.
®
is in it's Normal
15