Operating Guide; Prepare The Handheld Remote; To Insert And Remove The Batteries - Petsafe HDT11-13911 Instrucciones De Uso Y Manual De Adiestramiento

Step 1

Prepare the Handheld Remote

To Insert and Remove the Batteries

1. Slide off the battery cover (1A).
2. Install two (2), 3-volt (CR2032) batteries positive (+) side up (1B).
3. Slide the battery cover back in place (1C).
To verify the batteries are inserted correctly
1. Press any button on the Handheld Remote.
2. The Remote LED should flash to indicate a button has been pressed.
3. If the Remote LED doesn't flash, you may have inserted the batteries backwards. Try taking them out
and turning them over, ensuring that the (+) side is up.
4. If the Remote LED still does not flash, contact the Customer Care Center.
Risk of explosion if batteries are replaced by an incorrect type. Do not short circuit, mix
old and new batteries, dispose of in fire, or expose to water. When batteries are stored
or disposed, they must be protected from shorting. Dispose of used batteries properly.
Handheld Remote LED - Function and Response
Handheld Remote Function
Any button pressed
Low battery condition
8

Operating Guide

1A
LED Response
On for length of button press
LED flashes 3 times every 5 seconds
Customer Care Center 1-800-732-2677
1B 1C