Programming - Nice TT6 Instrucciones Y Advertencias Para La Instalación Y El Uso

TABLE 2 - Signalling LEDs
Led
DL1 Red LED
DL2 Yellow LED
DL3 Green LED
DL4
DL5, DL6 Red LED
DL7, DL8 Red LED
5 – PROGRAMMING
The control unit can memorise transmitters in two modes,
namely Mode I and Mode II:
Mode I
– Button 1 controls the Opening for the pre-set manoeuvre
duration (Tm) (maximum 240 sec.).
– Button 2 controls the Stop.
– Button 3 controls the Closing for the pre-set manoeuvre
duration (Tm) (maximum 240 sec.).
– Button 4 controls the Stop, once again.
Mode II
The transmitter button can be linked to one of the following
functions:
1 - Step-by-step
2 - Open
4 - English
Description
Power supply indicator.
If on, transmitter memorisation is
active.
Signals.
12 V signal trigger indicator.
External buttons open-close in-
dicator for mechanical motor.
Open-close relays activation.
3 - Close
4 - Stop
5 - Close after 10 sec.
6 - Open after 10 sec.
7 - Close after 20 sec.
8 - Open after 20 sec.
9 - Hold-to-run close
10 - Hold-to-run open
11 - Activate the list of programmed command linked to the
12v trigger Up scenario
12 - Activate the list of programmed command linked to the
12v trigger DOWN scenario
13 - Forward radio transmission on RS232 serial
5.1 – Memorising a transmitter in "Mode I"
01. Press and hold P1 on the control unit until the green
LED DL1 lights up (after approx. 4 seconds) then
release; the yellow LED DL2 will also turn on.
02. Within 10 seconds, press and hold any key of the transmit-
ter to be memorised, until the green LED DL1 on the con-
trol unit emits the first of 3 flashes to confirm memorisation.
Following these flashes, to memorise another transmitter in
"Mode I", press any key on the new transmitter within 10
seconds. Lastly, wait until yellow LED DL2 turns off.
Caution! – When attempting to memorise a transmitter that
is already stored, the green LED DL1 will signal this by flash-
ing once.
5.2 – Memorising a transmitter in "Mode II"
01. From the "Mode II" list, select the function to be pro-
grammed (e.g. "Function 8").