Disposal Of Unit; Electro-Magnetic Compatibility Precautions - Dentsply Sirona digit Power Manual De Uso

Interference may occur in the vicinity of equipment marked with the following symbol
Date of Manufacture
106
kPa
95%
%
80
5% kPa
Atmospheric

8. DISPOSAL OF UNIT

Fragile Relative Humidity Pressure Limitation
13Va
U.S. - Dispose of the system components in accordance with state and local laws.
EU - Dispose of in accordance with the Waste Electrical and Electronic Equipment Directive 2002/96/EC of the European Parliament and the Council of
the European Union.
9. ELECTRO-MAGNETIC COMPATIBILITY PRECAUTION
GUIDANCE AND MANUFACTURER'S DECLARATION – ELECTROMAGNETIC EMISSIONS
The digit Power Dispenser is intended for use in the electromagnetic environment specified below. The Customer or the user of the digit Power
®
Dispenser should assure that it is used in such an environment.
Emissions test Compliance
RF emissions Group 1
CISPR 11
RF Emissions Class B
CISPR 11
Harmonic emissions Class B
IEC 61000-3-2
Voltage fluctuations / Complies
flicker emissions
IEC 61000-3-3
GUIDANCE AND MANUFACTURER'S DECLARATION – ELECTROMAGNETIC IMMUNITY
The digit Power Dispenser is intended for use in the electromagnetic environment specified below. The customer or the end user of the digit Power
®
Dispenser should assure that it is used in such an environment.
Immunity test IEC 60601 test level
±8kV contact
Electromagnetic
±2, ±4, ±8, ±15kV air
discharge (ESD)
IEC 61000-4-2
Enclosure Port Tested as specified in Table 9 as
IEC 61000-4-3 per IEC 61000-4-3
±2 kV for power supply lines
Electrical fast
±1 kV for input/output lines
transient/burst
IEC 61000-4-4
±1 kV line(s) to line(s)
Surge
±2 kV line(s) to earth
IEC 61000-4-5
Voltage dips, short <5 % U
interruptions and or 0.5 cycle
voltage variations
on power supply 40 % U
input lines for 5 cycles
IEC 61000-4-11
70 % U
for 25 cycles
<5 % U
for 5 sec
Power frequency 3 A/m
(50/60 Hz)
magnetic field
IEC 61000-4-8
NOTE U is the a.c. mains voltage prior to application of the test level.
T
16
Electromagnetic environment - guidance
The digit Power Dispenser uses RF energy only for its internal function. Therefore, its RF emissions are very
®
low and are not likely to cause any interference in nearby electronic equipment.
The digit Power Dispenser is suitable for use in all establishments, including domestic establishments and
®
those directly connected to the public low-voltage power supply network that supplies buildings used for
domestic purposes.
Warning: This equipment/system is intended for use by healthcare professionals only. This equipment/system
may cause radio interference or may disrupt the operation of nearby equipment. It may be necessary to take
mitigation measures, such as re-orienting or relocating the digit Power
Compliance level
±8kV contact
±2, ±4, ±8, ±15kV air
Tested as specified in Table 9 as
per IEC 61000-4-3
±0.5, ±1, ±2kV mains
No I/O lines
±0.5, ±1kV Line to Line
±0.5, ±1, ±2kV Line to Earth
(>95 % dip in U ) f <5 % U
T T
for 0.5 cycle
(60 % dip in U ) 40 % U
T T
for 5 cycles
(30 % dip in U ) 70 % U
T T
for 25 cycles
(>95 % dip in U ) <5 % U
T T
for 5 sec
3 A/m
Electromagnetic environment - guidance
Floors should be wood, concrete or ceramic tile. If floors
are covered with synthetic material, the relative humidity
should be at least 30%.
Mains power quality should be that of a typical
commercial or hospital environment.
Mains power quality should be that of a typical
commercial or hospital environment.
(>95 % dip in U ) Mains power quality should be that of a typical
T T
commercial or hospital environment. If the user of the
digit Power
(60 % dip in U ) during power mains interruptions, it is recommended that
T T
the digit Power
from an uninterruptible power supply or a battery.
(30 % dip in U )
T T
(>95 % dip in U )
T T
Power frequency magnetic fields should be at levels
characteristic of a typical location in a typical commercial
or hospital environment.
Dispenser or shielding the location.
®
Dispenser requires handpiece charging
®
Dispenser charging base be powered
®
®
®