Synchronizing The Handpiece And Optional Wireless Foot Control; Preparation For Use - Dentsply Sirona digit Power Manual De Uso

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

• The handpiece should be recharged after each full day's use.
• If necessary, the handpiece may be "quick charged" for a single use in 15 minutes.
• When in the charging base, the handpiece motor is not allowed to operate.
• When fully charged, the battery icon in the display will be solid (not scrolling).
• The optional wireless foot control should be recharged when the charge state indicator light is solid orange.
• The foot control may be operated while charging.

3.5 Synchronizing the Handpiece and Optional Wireless Foot Control

Follow this procedure when:
• The optional wireless foot control or handpiece is replaced for any reason.
• The handpiece and optional wireless foot control do not seem to be communicating properly.
Handpiece must be placed in charging base and connected to power supply in order to pair with the foot control.
1. Place the optional wireless foot control within 10 feet of the charging base for handpiece.
2. Invert the optional wireless foot control.
3. Ensure foot control is on. To turn foot control on, depress the power button for 1 second.
4. Depress the "Sync" button on the selected optional wireless foot control for at least 2 seconds and release.
5. Immediately depress the On/Off/Mode button on the handpiece once for 3 seconds and release to complete pairing.
6. A successful sync is indicated by the appearance of the Bluetooth
control is blinking green.
7. The Bluetooth icon will change to a "foot on the pedal" when the paired foot control is pressed.
Synchronization Indicator Status (Handpiece and Optional Wireless Foot Control Sync Mode)
Device Indicator
Handpiece Display
Foot Control LEDs

3.6. Preparation for Use

1. Position the optional wireless foot control for use, ensuring that the floor is level.
2. Ensure that the handpiece (including cartridge cap) has been reprocessed according to Section 4, Hygiene and Maintenance.
Cross-contamination
Ensure the disposable polyethylene barrier has been correctly applied over the entirety of the handpiece and cartridge cap, with mixtip and
intraoral tip protruding through hole of barrier, before beginning a procedure.
This Polyethylene Sleeve does not replace cleaning and disinfection of the dental instruments. Please clean and reprocess dental instruments after
each patient as described in Section 4, Hygiene and Maintenance.
6
CHARGE STATUS FOR FOOT CONTROL
Solid green light
95-100%
Blinking green light
30-95%
Solid orange light
Less than 30%
icon on the handpiece changing from flashing to solid, and the sync indicator light on the foot
®
Ready to Pair
Bluetooth Icon Blinking
Blinking Blue
Successful Pairing
Failed Pairing
Solid Bluetooth Icon
Bluetooth Icon Gone
Blinking Green
Blinking Orange
Tabla de contenido

Solución de problemas

loading

Tabla de contenido