Bartscher E 5230 Manual De Instrucciones página 64

Prior to approving the electrical equipment for the use you must run it in a test mode to
ensure it operates properly, has no damages or problems.
→ → → → Turn the oven on by pressing
→ → → → Set the cooking/baking mode:
time: 10 minutes
T 16
Press to set START/STOP mode.
The following checklist requirements must be met to approve the oven for the use:
→ → → → The oven light is turned on by pressing the corresponding button and turns off
automatically after 45 seconds if it has not been turned off earlier by pressing
the button again.
→ → → → The oven shuts off as soon as the door is opened and restarts when the door is
closed again.
→ → → → The thermostat regulating the temperature inside the oven starts operating as
soon as the desired temperature is reached. The heating element (s) is/are
turned on and off from time to time.
→ → → → The fan(s) motor changes the direction of rotation automatically every 3 minutes.
→ → → → In ovens with two fans in the compartments, the motors rotate in the same
direction.
→ → → → Check whether water from the pipe comes to the humidification inlet (located in
the cooking compartment) towards the fan
→ → → → At the end of a cooking/baking cycle a beep signal sounds for about 15 seconds.
CAUTION!
An audible alarm can be heard when the oven is turned on. This is normal
and it will turn off automatically after a few seconds.
CAUTION!
Should the process be blocked during the setting of a cooking/baking phase
or should the control panel not respond for other reasons, this can be
corrected by repeatedly pressing
- 60 -
T 1
switch.
temperature: 50° – 150° C steam generati on: level 1
T 15
button.