Tabla de contenido
2
_To
install bagger components to tractor
1.
Discharge Chute
,,_._"_
,_/j
3.
Rat Washer
3/
_"
1.
2.
3.
4.
5.
3
Support Bracket
3/8 Carriage Bolt
1
3/8 Lock Nut
3/8 x 63,5mm Hex Bolt
10,3mm
(13/32")
flat
washer
5
2
•
Removedischargechutefmm
mar oftractor. Unhook the
two (2) straps and pull chute out and away from tractor.
•
Remove the two (2) 3/8 nuts and flat washers from the
bolts at the tractor back plate.
1.
3/8 Lock nut
2.
Flat Washer
3.
Support Tube
31
2,..
Using the nuts and fiat washers removed from tractor
back plate, install the bagger support tuba to the back
plate as shown. Tighten securely.
Install the two upper support brackets through the back
plate and to the chassis, using the 10 x 19 mm (3/8"x3/4")
carriage bolts and Iocknuts supplied. Tighten securely.
Assemble both support brackets to the outside of the
baggger support tube using two each 3/8 x 63,5mm he0(
bolts13/32" LD. flat washers and 3/8 Iocknuts from parts
bag. Tighten securely.
1.
Hook
2.
Discharge Chute _
3.
Back plate slot
•
Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate. This will allow the discharge chute to float with the
mower deck when moving on uneven terrain.
24
Tabla de contenido
