Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PROBLEM
CLOCK AND TIMER
DO NOT WORK
"FmAND
A NUMBER"
FLASH IN THE DISPLAY
THE DISPLAY GOES
BLANK OR INDICATOR
LIGHTS COME ON WHEN
THE RANGE IS NOT IN USE
OVEN LIGHT DOES NOT
COME ON
SURFACE LIGHT
DOES NOT WORK
OVEN WILL NOT WORK
OVEN TEMPERATURE
TOO HOT OR TOO COLD
FOOD DOES NOT ROAST
OR BAKE PROPERLY
,
_,
:
_i_
,
_
•
,i
_
OVEN SHELVES HAVE
BECOME DIFFICULT
TO SLIDE
"BURNING" or "OILY" ODOR
EMITTING FROM THE VENT
:
....
i
POSSIBLE
CAUSE
• Plug on the range is not completely inserted in the electrical outlet.
• Range electrical plug must be securely plugged into a live power outlet.
Check for blown fuse or tripped circuit breaker.
- Check for power outage_
• Review the Setting the Oven Control, Clock and Timer section of this guide.
•
If the time display flashes "F--and
a number", you have a function error code.
If a function error code appears during the self-cleaning
cycle, check the oven
door latch. The latch may have been moved, even if only slightly, from the
latched position. Make sure the latch is moved to the right as far as it will go.
Press the STOP/CLEAR
pad Allow the oven to cool for one hour.
Put the oven back into operation
° Disconnect all power to the range for 5 minutes and then reconnect power.
If the failure code repeats, then call fcr service.
• A fuse in your home may be blown or the circuit breaker tripped Replace the
fuse or reset the circuit breaker.
• The clock is turned off so that it does not show in the display. See the Using
the Clock and Timer section.
•
Bulb may be loose or burned out°
° Electrical ptug must be plugged into aiive
power outlet.
° Fluorescent bulb is loose or defective, Adjust or replace,
•
Switch operating light is broken. Cal! for service.
•
Plug on the range is not completely inserted in the electrical outlet.
= The circuit breaker in your house has been tripped, or a fuse has been blown,
•
Door feft in lock position after self-cleaning.
•
Oven controls not properly set,
• The oven thermostat
needs adjustment, See the Adjust the Oven
Thermostat--Do
FtYourself section.
° Oven controls not properly set. See the Baking or Roasting sections.
• Shelf position is not correct,
•
Incorrect cookware or cookware of improper' size is being used_
• Oven thermostat needs adjustment,
See the Adjust the Oven
ThermostatmDo
It Yourself section.
° Clock not set correctly,
° Aluminum foil used improperly in the oven.
• Oven bottom not securely seated in position. See the Installation Instructions section.
• The shelves were cleaned in a self-clean cycle. To make the shelves slide
more easily, apply a small amount of vegetable oil to a paper towel and wipe the
edges of the oven shelves or the oven shelf supports with the paper towel,
° This is normal in a new oven and will disappear in time, To speed the process,
set a self-clean cycle for a minimum of 3 hours. See the Using the Self Cleaning
Oven section,
48
Tabla de contenido
