Kenmore 362 7262 Manual De Uso Y Cuidado página 42

1. Install a manual g aslineshut-off v alveinthe gasline
in aneasilyaccessed l ocation outside of therange.
Makesureeveryone operating the rangeknows where
andhowto shutoffthegassupply tothe range.
2. Install m ale1/2" f lareunionadapter t othe 1/2" N PT
internal threadelbowatinletof pressure regulator,.
Usea back-up wrench ontheregulator f ittingto avoid
damage..
Wheninstalling the range fromthefront,
remove the 90 °
elbow for easier installation°
3. Install male W' or- 3A" flare union adapter to the NPT
internal thread of the manuaI shut-off valve, taking care
to back up the shut-off valve to keep it from turning.
4. Connect flexible metal appliance connector to the
adapter on the range_ Position range to permit
connection at the shut-off valve.
5. When all connections have been made, make sure all
range controls are in the off position and turn on the
main gas supply valve.. Use a liquid leak detector at all
joints and connections to check for leaks in the system.
I CAUT'ON =.DO NOTUSEA FLAMETO 1
CHECK FOR GAS LEAKS.
When using test pressures greater than V2psig to
pressure test the gas supply system of the residence,
disconnect the range and individual shut-off valve from
the gas supply piping. When using test pressures of V2
psig or tess to test the gas supply system, simply isolate
the range from the gas supply system by closing the
individuaf shut-off valve.
STEP 3
Electrical Connections
(on some models)
Electrical Requirements
120-volt, 60 Hertz, properly grounded branch circuit
protected by a 15-amp or 20-amp circuit breaker or time
delay fuse.
Extension Cord Cautions
Because of potential safety hazards associated with
certain conditions, we strongly recommend against the
use of an extension cord, However, if you still elect to use
an extension cord, it is absolutely necessary that it be a
UL-listed, 3-wire grounding4ype appliance extension cord
and that the current carrying rating of the cord in
amperes be equivalent to, or greater than, the branch
circuit rating
Grounding--IMPORTANT (Please read carefully)
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED.
The power cord of this
appliance is equipped
with a three-prong
(grounding) plug which
mates with a standard
three-prong grounding
wall receptacle to
minimize the possibility
of electric shock hazard
from this appliance.
PREFERRED
METHOD I _r_..
"_ before use
The customer should have the walt receptacle and
circuit checked by a qualified electrician to make sure
the receptacle is properly grounded.
Where a standard two-prong wall receptacle is
encountered, it is the personal responsibility and
obligation of the customer to have it replaced with
a properly grounded three-prong wall receptacle.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR
REMOVE THE THIRD (GROUND) PRONG FROM THE
POWER CORD.
Ground Fault Circuit Interrupters
Ground Fault Circuit Interrupters (GFCIs) are devices
that sense leakage of current in a circuit and automatically
switch off power when a threshold leakage level is
detected. These devices must be manually reset by
the consumer_
Although the National Electrical Code requires the use of
GFCIs in kitchen receptacles installed to serve countertop
appliances, GFCIs are not required or recommended in a
receptacle serving a gas range°
Performance of the range will not be affected
if operated on a GFCI-pretected circuit, but occasional
nuisance tripping of the GFCt breaker is possible.
If the breaker trips, power to the range wilt switch off.
42