To Replace The Front Work Lights (P 525Dx Cabin); To Replace A Parking Lamp; To Replace A Turn Signal Lamp; To Replace The Rear Work Lights (P 525Dx Cabin) - Husqvarna P 520DX Manual De Usuario

3. Push the spring lock and remove the lamp.
4. Put the new lamp into the lamp housing. Refer to
Technical data on page 58 .
5. Connect the cables to the new lamp.
6. Attach the lamp module and tighten the screws.

To replace a parking lamp

1. Remove the 4 screws that hold the lamp module and
lift it out.
2. Disconnect the cables from the broken lamp.
3. Remove the lamp.
4. Put the new lamp into the lamp housing. Refer to
Technical data on page 58 .
5. Connect the cables to the new lamp.
6. Attach the lamp module and tighten the screws.

To replace a turn signal lamp

1. Remove the 4 screws that hold the lamp module and
lift it out.
2. Disconnect the cables from the broken lamp.
3. Turn the lamp counterclockwise and remove the
lamp.
4. Put the new lamp into the lamp housing. Refer to
Technical data on page 58 .
5. Connect the cables to the new lamp.
6. Attach the lamp module and tighten the screws.
34
To replace the front work lights (P 525DX
Cabin)
1. Disconnect the cables from the broken lamp.
2. Turn the lamp counterclockwise and remove the
lamp.
3. Put the new lamp into the lamp housing. Refer to
Technical data on page 58 .
4. Connect the cables to the new lamp.
To replace the rear work lights (P 525DX
Cabin)
1. Disconnect the cable from the broken lamp.
2. Remove the screw on the lamp connector.
3. Remove the lamp connector with the lamp attached.
4. Install in the opposite sequence.
1593 - 002 - 22.12.2020