To Adjust The Ground Pressure Of The Hydraulic Lift Arms - Husqvarna P 520DX Manual De Usuario

2. Release the parking brake.
3. Carefully push down one of the pedals. The speed
increases the more the pedal is pushed down. Use
pedal (A) to move forward, and pedal (B) to move in
reverse.
A
4. Release the pedal to brake. To brake harder, push
down the other speed pedal.
5. Pull the PTO button to engage the operation of the
blades on the cutting deck.
To set the forward pedal positions (P 525DX,
P525DX Cabin)
The forward pedal can be set to transport speed or
working speed using the lock lever.
1593 - 002 - 22.12.2020
1. Move the lock lever from position (A) to position (B)
2. Lift the pedal until the lock lever moves into position
To adjust the ground pressure of the
hydraulic lift arms
B
The hydraulic lift arms has a lift spring that helps to
increase or decrease the ground pressure from the pivot
wheel on the cutting deck.
1. Remove the cutting deck. Refer to
2. Apply the parking brake.
3. Move the lever for the hydraulic lift arms rearward to
4. Turn the ignition key to the STOP position.
5. To increase or decrease the ground pressure,
to set the pedal to working speed.
A
B
(A) to set the pedal to transport speed.
cutting deck on page 18 .
fully lift the hydraulic lift arms.
remove the pin and the bolt and move the lift spring
to one of the positions.
A
B
C
D
a) Use position (A) for the lowest ground pressure.
Position (A) is used for example when a cutting
deck is attached to the product.
b) Use position (B) or (C) for increased ground
pressure.
c) Use position (D) to disengage the lift spring.
Position (D) is used for example when a snow
blade is attached to the product.
To remove the
25