Assembly; To Attach The Cutting Deck Combi 132, Combi - Husqvarna P 520DX Manual De Usuario

Ocultar thumbs Ver también para P 520DX:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

The engine is off.
The product is parked on a level surface.
The parking brake is applied.
The ignition key is removed.
The cutting deck is disengaged.
The main switch is set to off. Refer to
start the engine on page 24 .
WARNING:
the engine contain carbon monoxide, an
odorless, poisonous and very dangerous
gas. Do not run the product in closed spaces
or spaces with not sufficient air flow.
WARNING:
instructions that follow before you use the
product.
For best performance and safety, do maintenance
on the product regularly as given in the maintenance
Maintenance schedule on page
schedule. Refer to
29 .
Electrical shocks can cause injuries. Do not touch
the cables when the engine is on. Do not do a
function test on the ignition system with your fingers.
To attach the cutting deck Combi 132,
Combi 155
Note:
Make sure that the cutting deck and the product
are on level ground before you attach the cutting deck.
1. Put the lift lever to the position (B) to lower the lift
arms.
B
A
WARNING:
in the mow position (A). The force from
the lift spring can cause serious injury.
2. Carefully operate the product in front of the cutting
deck.
16
The exhaust fumes from
Read the warning

Assembly

Do not put the lift lever
Do not start the engine if the protective covers are
removed. There is a high risk of injury caused by
moving or hot parts.
Let the product become cool before you do
maintenance near the engine.
The blades are sharp and can cause cuts. Wind
To
protection around the blades or use protective
gloves when you do work on the blades.
Always put the cutting deck in servicing position to
clean it. Do not park the product near the edge of a
ditch or slope to get access to the cutting deck.
CAUTION:
instructions that follow before you use the
product.
Do not turn over the engine if the spark plug or
ignition cable is removed.
Make sure that all nuts and bolts are tightened
correctly and that the equipment is in good condition.
Do not change the adjustment of governors. If the
engine speed is too high, the product components
can become damaged. Refer to
page 58 for highest permitted engine speed.
The product is approved only with the equipment
supplied or recommended by the manufacturer.
3. Put the lift arms into the joint of the cutting deck.
4. Apply the parking brake.
5. Stop the engine.
6. Install the bolts (C) and attach the pins (D) on the lift
arms.
C
D
Read the caution
Technical data on
C
D
1593 - 002 - 22.12.2020
Tabla de contenido
loading

Este manual también es adecuado para:

P 525dxP 525dx cabin

Tabla de contenido