To Lift The Cutting Deck - Husqvarna P 520DX Manual De Usuario

a) Loosen the 2 locknuts (A).
C
C
b) Turn the rod (B) clockwise to make it shorter.
c) Put the pedal in transport speed mode.
d) Push the pedal down to a full stop against the
physical stop in the foot plate. Keep the pedal in
this position.
e) Adjust the rod (B) to make it longer, until it stops.
At this point the hydraulic pump has come to a
mechanical internal stop.
f) From this point, turn the rod (B) in the opposite
direction ½ turn to release the contact in the
hydraulic pump.
CAUTION:
correctly the hydraulic pump may be
damaged.
g) Tighten the locknuts.
1593 - 002 - 22.12.2020
B
A
If this is not done
4. To adjust the rearward pedal do the steps that
follow.
a) Turn the adjustment screw (C) on the wire to
adjust the position of the rearward pedal.
b) Push the pedal to full reverse. There must be a
10 mm clearance between the rearward pedal
and the foot plate.

To lift the cutting deck

1. Push the PTO button to disengage the drive of the
cutting deck.
2. Move the lift lever to transport position to lift the
cutting deck.
Note:
You can lift the cutting deck a small
distance with the drive on the blades engaged. Use
this function for very long grass or rough surfaces.
WARNING:
while the drive is engaged can throw
objects and cause serious injury or
death.
Lifting the cutting deck
23