To Adjust The Cutting Height Combi 132, Combi - Husqvarna P 520DX Manual De Usuario

To adjust the cutting height Combi 132,
Combi 155
1. Park the product on level ground.
2. Apply the parking brake.
3. Move the lever for the hydraulic lift arms rearward to
fully lift the cutting deck.
4. Turn the ignition key to the STOP position.
5. Remove the cutting height adjustment knob on the
side of the cutting deck.
6. Put the cutting height adjustment knob in 1 of the
holes on the adjustment plate.
Note:
The cutting height is shown with the
numbers 1–7. Refer to the table below.
Number Cutting height, mm/in.
1 30/1.2
2 40/1.6
3 52/2
4 64/2.5
5 76/2.3
6 93/3.7
7 112/4.4
7. Tighten the cutting height adjustment knob.
8. Do the above steps on the other side of the cutting
deck.
26
9. Remove the locking pin on the cutting height
adjustment lever in the top left corner of the cutting
deck.
10. Push the cutting height adjustment lever down and
pull the lever horizontally.
11. Put the lever in the hole with the same number as on
the adjustment plate.
Note:
Make sure the same number is selected on
all adjustment points.
12. Attach the locking pin on the cutting height
adjustment lever.
13. Adjust the parallelism of the cutting deck. Refer to adjust the parallelism of the cutting deck on page
36 .
To adjust the cutting height (Combi 132
X, Combi 155 X)
1. Park the product on level ground.
2. Move the lift lever for hydraulic lift forward to lower
the cutting deck to the mow position.
3. Move the cutting height lever forward and rearward
to adjust the cutting height.
Note:
The selected cutting height is shown with
the numbers 1–7 on the cutting deck. Refer to the
table below.
To
1593 - 002 - 22.12.2020