Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. Put the cutting deck in transport position. Refer to
To set the cutting deck in transport position or mow
position on page 13 .
4. Move the throttle control to the middle throttle
position.
5. Pull out the choke control.
6. Push down on the brake pedal fully and hold it down.
7. Put the ignition key into the ignition.
8. Turn the ignition key to the "START" position and
release the ignition key when the engine starts.
CAUTION:
starter continuously for more than 15
seconds for each minute.
9. When the engine starts, move the throttle control
to the fast position to warm up the engine. If the
temperature is low, some minutes is necessary for
the engine to get warm.
CAUTION:
temperature is less than 40° F (4° C),
you must let the engine operate 1 minute
at idle speed before you operate the
product. This is to let the transmission
warm up. Make sure that the brake pedal
is fully released.
10. Push in the choke control.
To set the cutting deck in transport
position or mow position
The cutting deck must be in transport position during
transportation.
•
To set the product in transport position, pull the
cutting height lever in the direction of the seat and
put it in the highest cutting height position.
•
To set the product in mow position, set the correct
cutting height. Refer to
page 13 .
1932 - 004 - 13.10.2022
Do not operate the
If the ambient
To set the cutting height on
To set the cutting height
•
Pull the lift lever in the direction of the seat and put it
in 1 of the notches for the correct cutting height.
To move forward and rearward
The direction and speed of movement is controlled by
the forward and reverse drive pedals.
1. Start the engine.
2. Disengage the parking brake. Refer to
and disengage the parking brake on page 14 .
3. To start movement, slowly push down on the forward
drive pedal (A) or the reverse drive pedal (B).
Note:
The forward and reverse drive pedals go
back to neutral position when they are not pushed
down.
4. Push down more on the forward drive pedal or the
reverse drive pedal to increase the speed.
To engage
A
B
13
Tabla de contenido
Solución de problemas
