Recommended Lubricants; After The First 8 Hours Service; Every 20 Hours Service; Every 100 Hours Service - breviglieri mekfold 300 Instrucciones De Empleo Y Mantenimiento

▪
Lubricate the hydraulic cylinder coupling pins
▪
Lubricate the side strip pins with grease
▪
Lubricate the telescopic tubes of the drivelines with grease
▪
Gear casings:
mekfold 300 version 500 ..........Kg 31 for casing
mekfold 300 version 600 ..........Kg 38 for casing
mekfold 300 version 700 ..........Kg 45 for casing
The indicated quantities correspond to a level about 1 cm below the upper edge of the gears in the casing when the machine is
on a flat surface.

5.2.1 RECOMMENDED LUBRICANTS

▪
It is advisable to lubricate the overdrive with: SAE 85W/140 oil, complying with API-GL5/MIL-L-2105C specifications.
▪
For all greasing points, the Manufacturer recommends: LITHIUM GREASE.
When servicing the driveline, strictly comply with the instructions given by the driveline Manufacturer, in the specific operation
and maintenance manual with which each driveline is equipped.

5.2.2 AFTER THE FIRST 8 HOURS SERVICE

Each new machine must be checked after the first 8 hours service. Proceed in the following way:
▪
Check the general condition of the machine
▪
Make sure that all the screws are well tightened
▪
Check the cutting tools for wear and make sure that the bolts that fasten them are well tightened
▪
Check the tension of the belts
▪
Check the level of the lubricants

5.2.3 EVERY 20 HOURS SERVICE

▪
Make sure that the screws that fix the cutting tools are well tightened
▪
Grease the driveline

5.2.4 EVERY 100 HOURS SERVICE

Check the level of the oil in the overdrive housing. If necessary, top it up through the plug on the top of the gearbox.

5.2.5 EVERY 500 HOURS SERVICE

Change the oil in the overdrive housing after every 500 hours service or at least once a year.

5.3 PREPARING FOR STORAGE

Proceed with the following operations at the end of the season or if the machine is to remain idle for a long period of time:
▪
Wash all fertilizers and chemical products from the machine and dry it
▪
Carefully check the machine and replace any damaged or worn parts
▪
Fully tighten all the screws and bolts, particularly the ones that fix the tines
▪
Throughly grease the machine and then cover it with a tarpaulin and store it in a dry place. If these operations are carried
out with care, it will be all to the user's advantage as the machine will be in optimum conditions when needed again.
If these operations are carried out with care, it will be all to the user's advantage as the machine will be in optimum conditions
when needed again. If the machine must be dismantled, comply with the anti-pollution laws in force. Old lubricants must
and the various components must be disposed of according to their different structures.

5.4 SPARE PARTS

All the parts forming the machine can be ordered from the Manufacturer, specifying:
▪
Machine model
▪
The serial number of the machine
▪
The year of manufacture
▪
The serial number of the required part (indicated in the spare parts catalogue), a description of the part and the required
quantity
▪
The means of transport
mekfold 300
- 37 -
macchine agricole