Feeding In The Wire - Abicor Binzel PP Plus 36D Instructivo De Servicio

4 Putting into operation

4.8 Feeding in the wire

1 Housing cover
2 Knurled screw
3 Clamp clip
Fig. 7 Feeding in the wire
EN - 12
1
7
4 Pressure adjustment knob
5 Wire feed roll support
NOTE
• Each time the wire is changed, make sure that the cutting point is free of
burrs.
• Make sure that the wire feed roll complies with the diameter of the
inserted wire electrode.
 8.1 Replacing the wire feed roll on page EN-14
1 Insert the wire in the wire feeder as specified by the manufacturer.
2 Open the housing cover (1) at the handle.
3 Unscrew the clamp clip (3) by pressing the pressure adjustment knob (4)
upward and swivel it out laterally.
4 Press the "Current free wire feed" trigger at the wire feeder until the wire
comes out of the contact tip.
5 Lock the clamp clip (3) and close the housing cover (1).
2 3
4
5
6
6 Wire feed roll
7 Seat
PP Plus 36D/401D