Checking Threaded Fasteners Tightened In The "Tightening" Operating Mode - Hilti SI­-AT-­A22 Manual De Instrucciones Original

Result 1 / 2
The fastener was not turned further than through the specified maximum
angle of rotation (α).
Installation of the threaded fastener undertaken in the "Adaptive" operat-
ing mode was performed correctly; the specified installation torque was
achieved.
Result 2 / 2
The fastening element was turned further than the specified maximum
angle of rotation (α).
Installation of the threaded fastener undertaken in the "Adaptive" oper-
ating mode is faulty, because the specified installation torque was not
achieved. The threaded fasteners tightened since the previous check are
to be regarded as faulty and must be checked. Have the impact wrench
checked by Hilti Service.
5.10.2 Checking threaded fasteners tightened in the "Tightening"
operating mode
▶ At regular intervals, using a calibrated torque wrench and proceeding
in accordance with company regulations or quality specifications, check
that specified tightening torque has been achieved.
5.11 Removing the torque module
1. Remove the battery.
2. Press and hold down the release button of the torque module.
3. Pull the torque module to the rear and off the impact wrench.
5.12 Connecting the torque module to a PC
1. Remove the torque module.
2. Open the sliding cover on the underside of the torque module.
◁ The USB port is accessible.
3. Plug the connector of the USB cable (type B, USB 2.0) into the USB port
of the torque module.
4. Plug the other connector of the USB cable (type A) into the PC.
◁ The torque module is now powered off the PC. The USB logo
appears on the module's display.
Note
After unplugging the USB cable from the torque module, close the
cover over the USB port to protect it from dirt and dust.
16 English
Printed: 15.09.2017 | Doc-Nr: PUB / 5331558 / 000 / 01
6
7