Error Messages - Mx Onda MX-PI2612 Manual De Usuario E Instalacion

ERROR MESSAGES

If an abnormality arises, the induction hob will enter the protection state
automatically and display the corresponding error codes:
Message
Protection against under voltage (<85
E 1 / E 2
V) or over voltage (> 285 V)
Induction coil temperature sensor
E 3
fault.
E 4
IGBT temperature sensor failure
High temperature (> 280 ºC) of the
E 5
induction coil temperature sensor.
E 6
High temperature at IGBT sensor
E r
Internal fault of the control circuits.
There is excess liquid on the buttons
r
on the control panel
INSTALLATION
Drill a hole in the worktop based on the following suggestions:
It must leave
minimum of 5 cm around the
hole, free
(furniture, electrical appliances,
etc.).
The thickness of the worktop is
at least 30 mm.
Choose the material of the
worktop that is heat resistant to
avoid deformation caused by
heat radiation
induction hob.
A(mm)
275
Under any circumstances, make sure that the induction hob is well ventilated
and that the air inlets and outlets are not blocked.
Description
at least
of obstacles
from
B(mm) C(mm)
490
If the voltage at the mains outlet is lower or
higher than specified, consult a qualified
electrician.
Contact the closest MX ONDA Official
Technical Service.
Contact the closest MX ONDA Official
Technical Service.
Turn off the induction hob and wait for it to
cool down.
Check that the ventilation is correct and the
fans are not obstructed.
Contact the closest MX ONDA Official
Technical Service.
Clean and dry the control panel
a
the
D(mm)
50mm 50 mm
18
Solution
E(mm) F(mm)
50 mm 50 mm