Hourmeter; Reset Button; Connectionplugs; Vac, 20 Amp, Duplex Receptacle - Generac GP Serie Manual Del Proprietário

Figure 2C - Contro/ Pane/ (CSA Models)
Figure3 - GeneratorControls
2.2 HOURMETER
TheHourmetertracks hoursof operationfor scheduledmaintenance
(Figure5):
Therewill be a "CHGOIL"messageevery 100 hours. The message
will flash one hour before and one hour after each 100 hour
interval, providinga two hour window to perform service.
This messagewill actually begin flashing at 99 hours and disable
itself at 101 hours again,providing a two hour window to perform
the service.
Every 200 hours the "SVC" icon on the lower left hand corner of
the display will flash. The messagewill flash one hour before and
one hour after each200 hour interval providinga two hour window
to perform service.
Figure5 - Hourmeter
HOUR GLASS
GRAPHIC
O000.O
RESET BUTTON
(IF EQUIPPED)
Figure4 - Generator Controls
Whenthe hour meter is in the FlashAlert mode, the maintenance
message will always alternate with elapsed time in hours and
tenths. The hours wilt flash four times, then alternate with the
maintenancemessagefour times until the meter resets itself.
* 100 hours - CHGOIL-- Oil ChangeInterval(Every 100 hrs)
* 200 hours - SVC-- Service Air Filter (Every 200 hrs)
Note:
The hour glass graphic will flash on and off when the engine
is running. This signifies that the meter is tracking hours of
operation.
2.3 CONNECTION PLUGS
2.3.1 120VAC, 2 0AMP, D UPLEX R ECEPTACLE
This is a 120 Volt outlet protectedagainst overloadby a 20 Amp
push-to-reset circuit breaker (Figure6). Use each socket to power
120 Volt AC, single phase, 60 Hz electrical loads requiring up to a
combined 2400 watts (2.4 kW) or 20 Amps of current. Use only
high quality, well-insulated, 3-wire grounded cord sets rated for
125 Volts at 20 Amps (or greater).
Keep extensioncords as short as possible, preferably less than
15 feet long, to preventvoltage drop and possible overheating of
wires.