Tabla de contenido
2
O
To install
components to tractor
bagger
1.
Discharge Chute
2.
3/8 Nut
3.
Flat Washer
J
3
1. Suppod Bracket
2.
3/8 Carriage Bolt
1
3.
3/8 Look Nut
4.
3/8 x 63,5mm Hex Bolt
5.
lO,3mm
(13/32')
flat
washer
2
\
1.
2.
3.
Removedischargechute from raar of tractor. Unhook the
two (2) straps and pull chute out and away from tractor.
Remove the two (2) 3/8 nuts and flat washers from the
bolts at the tractor back plate.
3/8 Lock nut
Flat Washer
SupportTube
Using the nuts and flat washers removedfrom tractor
back plate, installthe baggersupporttube to the back
plate as shown.Tightensecurely.
Install the two upper support brackets through the back
plate and to the chassis, using the t 0 x 19 mm (3/8"x3/4")
carriage bolts and Iocknuts supplied. Tighten securely.
Assemble
both support brackets to the outside of the
baggger support tube using two each 3/8 x 63,5mm hex
bolts13/32" I.D. fiat washers and 3/8 Iooknuts from parts
bag. Tighten securely.
1. Hook
2.
Discharge (
3.
Back plate slot
3
•
Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor back
plate. This will allow the discharge chute to float with the
mower deck when moving on uneven terrain.
24
Tabla de contenido
